DIY Tips for Perfect Skirting Board Installation At Home

Skirting boards are important for a room. Also referred to as baseboards, skirting boards can easily be installed. If you want to replace the old with fresh new boards to give your room a makeover we will tell you how to go about with the process but first you will need to have certain basic supplies and tools for the DIY project. Let’s have a look:

Removing the Old Boards and Measuring the Walls

Skirting boards are a part of the wall. That’s why when you want replacements you will need to remove the older boards. To remove an old skirting first get a bolster chisel. Using a hammer gently tap blades of the bolster chisel. Now, insert the crowbar in between gaps and take off the board from the wall.

Use Measuring Tapes to Take Measurement of the Wall

Stretch the tape and take measurement by placing it along the bottom of a wall. Write down the measurements and add them up. Meanwhile you can draw a sketch of the available space for flawless skirting board installation in Kellyville.

Purchase Skirting Boards at Least 20% in Excess

Suppose you will need 9 meters of skirting board, order at least 20% in excess to allow for losses during the installation process.

Cutting the Board

First have your target set on a wall which has internal corners. Now, cut squares on the board. Generally an internal wall will have at least 2 corners. Mark it on a skirting board and cut out the pieces such that they fit well on the wall. Make straight and precise cuts. If you think this is too confusing hire professional skirting board installation service in Baulkham Hills.

Cut Boards Using a Coping Saw to Fit Around the Face of the First Board

At this point, just cut the end of the board at 45 degrees so that it fits edge to edge with the other square board. The coping saw will help cut off the excess portion of the square. Follow the board’s profile to cut pieces that will fit around the internal corners.

Plan Your Cuts Systematically

If a wall has a pair of internal corners, cut a single square of the board from one end and scribe an end of another board so that it fits around the edges of the previous board.

Use the Miter Saw for Cutting Boards at 45° for the External Corners

Find out and measure how far the end of the board will go to reach the external corner. Now take your marker and mark the backside of the board from where you will cut its end. Use a miter saw and cut the backside of the board at a 45°.

Cut the External End of a Second Board From an Opposite 45° Angle

Take the miter saw and move it to the other axis of another board which needs to fit around the external corner. Suppose you have cut the first board at 45 degrees to its left; now move on to the next board and cut its end at 45 degrees to its right. Fit these two boards to the external corner of the wall end and make adjustments if required. Most of the time householders don’t want to get into the complications and prefer hiring skirting board installation services near Norwest.

Attaching the Board

Use instant adhesive to attach the boards to plasterboard. Spread the adhesive in zig zag manner at the back of boards. Now press them tightly against bottom edges of the wall. Wipe off any excess adhesive seeping out of the edges.

After you have marked the studs placed in the plaster wall, screw up the boards into them. Drill a hole into the board and allow it to countersink with the drill bit. Use screws to attach the boards in place.

After you have attached the boards fill in the gaps using decorator’s caulk. Also, do not forget to cover up the screws with the help of wood filler.

Finally you have achieved a complicated task like skirting board installation. Every time you need to install skirting boards, refer to these points.